Calculation

An AFDD takes two ways. Therefore if in 1L1, 1L2 cannot be allocated to a circuit. The software should know this and should blank the way out. On the left of a TP board it is the following way that becomes unusable (as above) but on the right of a...

Installations may have circuits that are not being altered/changed as part of the works but circuits will be drawn to allow loads to be properly calculated. Having a setting to stop these cables being generated in reports would be helpful rather t...

Add the devices from Protect into ProDesign so that I can correctly configure the source of supply. The list of available devices in ProDesign for LV and especially HV protection at source is rather limited.

Construction & site engineers to use different rating generators in parallel to supply for temporary supply in site.

I don't understand why, for circuits supplying inverters, when you look at the cable temperature it only shows ambient temp and not what the cable temp would be under full load/capacity. Can this be added please?

Display Results for motors shows many useful parameter values, for some reason the motor starting current is missing for the motors interface. Seeing this value on the canvas would allow me to select an appropriate circuit protective device for an...

Often SWA cables are installed below raised access floors within commercial office buildings especially for underfloor power tracks. It would be very useful to have this as an installation option rather than having to pick another method B and hav...

Modular RCDs can have adjustable time delay and adjustable tripping current as well as coming in a variety of current capacity ratings that are not present in ProDesign. At the moment only Instantaneous and Selective RCDs up to 100A are generally ...

Max. lengte spanningsverl. NIET zichtbaar in het schema