Trimble Electrical Designer

An AFDD takes two ways. Therefore if in 1L1, 1L2 cannot be allocated to a circuit. The software should know this and should blank the way out. On the left of a TP board it is the following way that becomes unusable (as above) but on the right of a...

We build a number of standard/package plant systems. All identical other than client specific numbering on components and cables. Current set up means you have to open every item to rename, can there not be a find and replace function?

Following updates stop replacing the logo with the Trimble logo. If it has been changed leave it with the new logo.

Have standard microsoft colour palettes available for boxes/text etc. Option to have full colour spectrum (as is current) can be retained but over complicated for most applications and a pain to then match colours or reset to standard (black/white...

Be able to add final circuits or transformers with two phase loads. Control transformers in switchgear/plant rooms will often use two phase 400Vac supply.

Installations may have circuits that are not being altered/changed as part of the works but circuits will be drawn to allow loads to be properly calculated. Having a setting to stop these cables being generated in reports would be helpful rather t...

When inserting a Final Circuit have the ability to move junction boxes to a desired position rather than automatic spacing. Alternatively allow final circuits to be connected to Junction Boxes

Could it be possible to select the reports wanted for export to PDF and then ProDesign includes them all into one documents with Titlepage and contents table and then the selected reports in order? I've received some electrical OM reports for revi...

Add an option to allow the use of cables greater than 300mm2 for multicore XLPE/SWA CU cables.

When the Installation Method is changed the CPC configuration should be retained. The current functionality creates needless work.